Futaba GY Pdf User Manuals. View online or download Futaba GY Instruction Manual. Nstruction, Anual • Read online or download PDF • Futaba GY User Manual. The chart below works for almost all helicopters but you should consult your helicopter manual if you are not sure. Note that I have seen.
|Published (Last):||16 March 2016|
|PDF File Size:||1.42 Mb|
|ePub File Size:||16.57 Mb|
|Price:||Free* [*Free Regsitration Required]|
There are three things that need to be connected. If you cannot stop the wagging, rotate the gyro 90 degrees. Heading Hold Solid Blue: Quickly press and release the gyro button to change the direction. Once you set the travel for this side, quickly press and release the button on the gyro. This needs to occur when you move the stick left as well as right. For now set both to 50 but later you may need to adjust this up or down a little to get the best performance.
For manial to class mount it about Do the same for ‘GEAR’.
The light on the gyro will turn solid Blue. Move the nose of the helicopter left and verify the trailing edge of the tail blades move to the right.
Mahual black wires will be away from the labels. Use a real email address or you will not be granted access to the site. If you need to readjust then quickly press and release the gyro button.
Futaba GY520 User Manual
At the left, look at the top picture. This tells the radio that you want to control the Gear channel of the receiver by using the switch on the radio that is labeled Gear.
With it in this position the gyro will be in heading hold with the gear switch up position 0. He is running a DX7. You will see the servo move to one side. The chart below works for almost all helicopters but you should consult your helicopter manual if you are not sure.
It puts the gyro in a standard rate mode so the servo will center when the rudder stick is centered. Please provide as much info as you can. Power up the radio and the receiver.
The servo needs to rotate in the direction that would cause the trailing edge of the tail blades to move to the right side of the helicopter. Note the color of this light.
GY Setup – HeliFreak
Move the rudder stick right and verify the trailing edge of the tail blades move to the right. If not, then enter setup mode of the gyro hold the button for 3 seconds. It will be connected later. The blue label on the gyro needs to be either up or down. Posting Quick Reply – Please Wait.
The gyro could be set for the wrong type servo. The next second it will blink fast.
One direction will set the gain value for heading hold and the other will be for standard rate. My setup on the miniTitan is Also make sure that your plugs in the receiver have the correct polarity.
The light will change to a violet color. You should make the decision based on what your flying style is. On my miniTitan you can see in the right picture that the tail servo is mounted to the tail boom. I was helping my buddy manuak he wanted me to hover it, so as soon as I did, the tail was super wobbly. Just hold it on top of the ball.
It is great they did this so you do not get mixed up. Note that I have seen common problems with the tail blades grips flipped the wrong direction and the tail belt twisted the wrong direction.
gj520 If the gyro is set for the wrong direction the helicopter will spin extremely fast as soon as it gets light on the skids. With the rudder link disconnected from the servo. Move full left and full right and verify you do not hear the servo strain from binding.