Our 33 Litre Front Loading Benchtop Autoclave, available in Classic and Autofill versions, is ideal for laboratory research and is low in water. Have a question about Autoclaves, Sterilizers or Steam Generators? Our FAQ page has the answers. All the machines are supplied with a user manual but sometimes it is not consulted! Astell offer training to operators, and this is a service I recommend to ensure.
|Published (Last):||9 July 2016|
|PDF File Size:||17.71 Mb|
|ePub File Size:||2.92 Mb|
|Price:||Free* [*Free Regsitration Required]|
Small bottles, tubes, etc may need Freesteaming up to the maximum allowed time. Is it possible to keep media warm autoclae Holdwarm whilst removing bottles from time to time? If ON only the supervisor may select Programs, via the Key button.
33 Litre Front Loading Benchtop Autoclave | Astell UK
Note;Never lean on the handle or hang anything over the handle as this will cause the bolt to stick and will cause early failure of the mechanism. The printer can also be used to provide reports of cycle settings and servicing information. Setting a higher temperature autcolave speed up cooling but will increase boiling-over and loss of the load contents on Bottled Fluid Loads, e.
Most manufacturers request a deionised water supply. The top line shows the Current Sterilize Temperatureand Sterilize time. By gradually reducing the boost as the load gets nearer to the desired temperatureit does not appreciably overshoot the desired setting. The water inlet is controlled by a level switch and complies with water bylaw regulations.
Autoclave service and maintenance – advice from the experts Want to know how best to maintain your autoclave? You need to also purchase the 5 position shelf rack to use this option. Temperature Readout At top – left of display during running Programs.
Our service staff are able to repair or maintain your equipment on site if required. Small front loading autoclave. This will be accompanied by a longer audible beep tone.
This allows the chamber to be cleaned out.
Settings may be ajtoclave in any order. The media will be kept warm for up to 48 Hrs. Prevents starting a cycle with a dangerously hot chamber. A benchtop autoclave has a variety of uses, being suitable for sterilizing laboratory glassware, plastic receptacles and containers, petri dishes, un-wrapped instruments, media, and occasional discard loads.
Incorrect configuration may cause damage to the control system. Mainly southern England Time in job: All three of the Benchtop zstell use the same discard container, but have different capacities as follows: This setting will be as required to ensure correct operation.
The key should be kept in a safe place. Not all will show on all models. Are Classic or Autofill Compact and Benchtop autoclaves best for discard?
Autoclave service and maintenance – advice from the experts
The ‘Swiftlock’ front loading range of autoclaves qstell the user a greater choice of options unavailable on the smaller ranges, as well as easy loading access. Unit includes a separate brine tank, allowing installation in difficult or restricted positions. It must be set to an appropriate temperature that will operate safely for all programs and loads. Note;- This requires the printer option to be fitted.
The Holdwarm temperature is automatically set to 25C below the Programmable Cooling-lock temperature set in the program. You are encouraged to provide photos or video showing any faults through email or via the Technical Assistance page on our autodlave. Press the function key under the LCD display. The stages are as follows ; Note times, etc shown are illustrative and do not represent actual cycles. If not it will display on the screen and requires keypresses to step through the report one line at a time so that it may be written down.
Yes, Astell autoclaves are registered Medical Devices.
The Display then shows the details of the Program Profile settings for the program that has been started, and the Cycle Counter reading. Ours only need a potable asttell supply. Water Solenoid Valve Feeds water to chamber. What one tool in your service kit bag could you not do without?